CVE-2026-99578

In the Linux kernel, the following vulnerability has been resolved:

wifi: rtw88: usb: route bmc frames via the high queue only for DTIM delivery

In AP mode every broadcast and multicast data frame is routed to
TX_DESC_QSEL_HIGH, the after-DTIM queue, whether or not anybody is
asleep. The firmware drains that queue at beacon pace, a dozen or so
frames per second measured on RTL8822BU, while one associated client's
mDNS/SSDP chatter alone exceeds that. The excess accumulates inside
the chip until the shared TX page pool is exhausted (measured: 14 of
1803 pages left). From that point every host-sourced frame queues
behind the backlog: authentication responses reach the air seconds
after the client has given up, so no station can associate anymore,
and the beacon reserved-page download fails the BCN_VALID poll
("error beacon valid") because it needs pages from the same pool. The
AP keeps beaconing, so the failure looks like a silent RX stall and
only a reboot recovers.

mac80211 already decides when after-DTIM delivery is needed: it sets
IEEE80211_TX_CTL_SEND_AFTER_DTIM on bmc frames only while at least one
station is actually dozing. Honor that instead of routing
unconditionally: flagged frames keep going through the high queue with
the MORE_DATA and HGQMD handling introduced by commit 076f786a0ae1
("wifi: rtw88: Fix AP mode incorrect DTIM behavior"), everything else
leaves at line rate through the AC queues. This partially reverts the
usb.c hunk of that commit, whose unconditional routing is what lets
the backlog build up.

On a bench AP (USB2, 20 MHz, WPA2, hostapd, a Windows client driven
through disconnect/reconnect cycles): reconnects fail 0/5 on RTL8822BU
and 0/3 on RTL8821CU before this change, and pass 10/10 and 5/5 with
it, with the page pool staying healthy and no beacon errors logged.

Bu kayıt NIST NVD kaynağından aktarılmıştır. Etkilenen sürümler, güncel değerlendirme ve üretici referansları için kaynak kaydı inceleyin.

← Tüm yazılara dön